Note: Actual values observed 50 mm from the end of the fiber when light intensity control is set at 100% and a straight light guide with a joint diameter of 8 mm is attached. (Reference values)

Note: Actual values observed 50 mm from the end of the fiber when a straight light guide with a joint diameter of 8 mm is attached. (Values not guaranteed)

Note: Images taken with the light intensity control set at the maximum value, when a straight light guide with a joint diameter of 8 mm is attached, and using the same fiber.

Note: Actual values observed 50 mm from the end of the fiber when light intensity control is set at 100% and a straight light guide with a joint diameter of 8 mm is attached. (Values not guaranteed)

Note: Observed using a thermograph one hour after continuous lighting is turned on with light intensity control of 100%. (Data not guaranteed)

Note: Calculated values until the light output decreases to 70% at a light intensity of 100% and an ambient temperature of 25Cº. (Value not guaranteed)

Note: An illustration of a comparison of the light output variation between our LED light source until its lifetime ends, and a halogen lamp replaced every 1,000 hours.

Note: A comparison between the PFB-20SW and a 100W halogen lamp when they are lit for 24 hours with the light intensity set at a maximum, and using an electricity rate of 9 yen per 1 kWh/month which does not include the basic charge.

Note: Total cost image by the comparison between PFB-20SW and 100W halogen.